For more information on any of these products please contact a Sales Rep at 978-664-5311

Standard Features:

 - Self-leveling mounting with quick attach/detach hardware.
 - Bi-directional operation allows for right or left hand discharge.
 - Adjustable feed gates are hinged at each end of conveyor.
 - 18” wide chain with High-temperature belt riveted to each drag bar.
 - Spreads a wide variety of materials including aggregates and hot
  mix asphalt.
 - Performs shoulder maintenance, asphalt-patching, ice control,
  rut-filling, and earthen conveying. Mounts at rear of dump body
  below regular dump box tailgate.

Standard Features:

 - Quick detach mounting hardware.
 - Urethane Spinner will not rust or corrode. More effective material
  dispersal with less waste.
 - Urethane Spinner will not rust or corrode.
 - More effective material dispersal with less waste
 - Self Leveling spinner assembly allows spinner disc to remain
  parallel to the road at any dump body angle.
 - Berm Chute is self-storing and adjustable for alteration of material flow
 - The VCT 90 has a Heavy Duty 9” auger, directly coupled to a High
  Torque hydraulic motor through a stainless steel coupler. The
  hinged lower trough swings clear to allows material to fall through
  the auger area to simplify clean-out and removal of any blockage

Standard Features

 - Overall conveyor width is 6-3/4”
 - Material feed gate is controlled by a lever and chain arrangement,
  without opening engine hood
 - Spinner Assembly features molded 14” urethane HD disc with four
  vanes, driven by #40 chain from gear box input shaft.
 - Material chute has two internal adjustable deflectors and four
  external deflectors. Optional 12” and 18” extensions are available
  for larger trucks.

Standard Features

 - Material feed gate is adjustable with self-locking screw jack and
  opening is 10” high X 19” wide.
 - Conveyor Drive features 2 Char-Lynn drive motors, one each end
  of conveyor drive, 50:1 high efficiency chain and sprocket
  reduction, provides higher torques and conveyor speeds.
 - Spinner and Chute is 3/16” steel 18” diameter spinner disc mounted
  directly on Char-Lynn hydraulic motor shaft. Three-piece chute
  constructed of #10 gauge minimum material, bolted for easy
  replacement. Three-steel adjustable external deflectors.

Standard Features

 - Material feed gate is lever and chain operated with an opening of
  10” high X 19” wide.
 - Cab Control equipped with toggle switch for throttle/choke, toggle
  switch for electric clutch on/off, key switch, and light for electric
  clutch.Spinner Assembly features molded 14” urethane HD disc
  with four vanes, driven by hydraulic motor coupled to spinner shaft
 - Material chute has two internal adjustable deflectors and four
  external deflectors. Optional 18” extension is available for larger
  trucks

Standard Features

 - Material feed gate is lever and chain operated with an opening of
  10” high X 19” wide.
 - Char-Lynn hydraulic motor coupled to input shaft drives gearbox
 - Worm gear is aluminum/bronze alloy with 90,000 lbs tensile
  strength
 - Spinner and Chute is 3/16” steel 18” diameter spinner disc mounted
  directly on Char-Lynn hydraulic motor shaft. One-piece #10 gauge
  welded construction of chute, four-steel external deflectors, one
  fixed and three adjustable

Flink and Baker products are all made in the USA.

Click here to visit the Flink website.